University of Illinois - Department of Electrical and Computer Engineering
This board was designed by Skot Wiedmann
and was fabricated and photographed by Mark Smart. This image ended up being used as a basis for the
at the new ECE Building!
We use a no-chemical milling process to fabricate prototype printed
circuit boards. We use
which is 0.06" thick with 1oz. copper on one or both sides.
Requests can be submitted via email as described below. Boards
are usually completed within one week. Finished boards are left in the
green box on the left bench in Room 1042.
Sorry, but we can't do boards with internal layers, internal power or
ground planes, plated feed-throughs, solder masks or silk screens.
Back to ECE Shop Index
Rooms 1041-1046 ECE Building
306 N. Wright Urbana, IL 61801